wiring massive audio subwoofers

Can somebody please help i used the woofer wiring wizard but my amp is still going into protection mode here is what i have a Sony XM-2200GTX   1200 Watts 2-channel amp and two Massive Audio Subwoofer CW 12 Stage the subs say there 2.5 voice coil whatever that means but i followed the wizzard and ran them (series/parallel) bridged out to my amp and i power on the system the light on amp is green but if i turn vol fast 4 the light turns red thank you for your input if any and have a good day!!

Thanks to who ever fixed my forum topic !!

Go to the Hot Topics forum and read "How to Set Your Gains" to make sure you have set the gain on your amp properly.Support the12volt.com

Well your amp is 4 ohm stable bridged and if your wired correctly series paralell then with your subs your at 4 ohms. Meter the wires to your subs disconnected from the amp to verify they are wired at 4 ohms. If so start checking things. Grounds. Wire gauges etc.Gary Sather

You can't wire two of those subs to be bridged at 4 ohms. The subs are DVC woofers so you would have to wire them @ 8 ohms to bridge them at the amp safely. The ohm load is probably below 4 ohms bridged at the amp which is causing the amp to go into protection mode. I would probably run the woofers in stereo at the amp @ 4 ohms per channel or get a mono amp rated at 1200w RMS @ 2 ohms. Possibly a Massive N4 but thats 1000w @ 2 ohms RMS? That amp would work great but the selections out there are endless.I drink current, eat ohms, and bleed voltage