blowing fuses on PPI a600.2

Home / the12volt's Install Bay / Car Audio / blowing fuses on PPI a600.2 (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Big Blue

Member - Posts: 2

Joined: January 31, 2003

Location: Canada

Posted: January 31, 2003 at 3:11 PM / IP Logged

I have an older PPI a600.2 driving a JL Audio sub. The amp just started blowing fuses at moderate to loud listening levels. I have a 120 amp fuse under the hood that goes to a fused dist block. The amplifer has a dedicated 50amp fuse at the dist block. The cable is less then 10" and totally visible. It is the only fuse blowing. The onboard 60amp fuse on the amp does not blow. Any Ideas?

Big Purds

Silver - Posts: 574

Joined: November 25, 2002

Location: Canada

Posted: January 31, 2003 at 3:44 PM / IP Logged

bad ground or connection somewhere...something is touching something it shouldnt somewhere in that line...

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

blowing fuses on PPI a600.2

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.