98 blazer ingear problem

Home / the12volt's Install Bay / Car Security and Convenience / 98 blazer ingear problem (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

USMC Vet

Copper - Posts: 64

Joined: January 22, 2005

Location: United States

Posted: February 02, 2008 at 7:44 PM / IP Logged

Installing RS on A 1998 Blazer. Auto Command. Does this vehicle have a 3rd Ign.? Vehicle starts and runs for 10 seconds, works fine with key. Troubleshoot code says vehicle was shifted into gear. I used resistors to bypass Passlock 2. The 3rd I gn wire from the RS module I hooked up to the relay is a ground output. Should this 3rd ignition power a relay first ? Thanks !

Back to Top

brhaugen

Copper - Posts: 275

Joined: September 30, 2005

Location: North Dakota, United States

Posted: February 03, 2008 at 8:26 AM / IP Logged

Did you use this diagram to bypass the passkey 2? https://www.the12volt.com/installbay/file.asp?ID=250

You may want to use a "ground output when running" or "status output" wire to power your relays, it comes on BEFORE the ignition outputs.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

98 blazer ingear problem

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.