bulldog security

Home / the12volt's Install Bay / Car Security and Convenience / bulldog security (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

alan bindrup

Member - Posts: 3

Joined: November 17, 2009

Location: Utah, United States

Posted: November 19, 2009 at 1:01 PM / IP Logged

I've installed a Bulldog Security remote start, along with a PKUCG2X bypass into my 2008 Dodge Ram half ton gasoline fueled hemi. Everything works, (ignition on and off, lights, doorlocks, etc.), but she will not crank the starter. I am getting a ground trigger out of the bypass to the MUX wire aat the keyswitch, but it must be the wrong value. Does anyone know if I need to add a resistor and what value?

Thanks

dasbogie

Silver - Posts: 514

Joined: September 30, 2006

Location: Pennsylvania, United States

Posted: November 19, 2009 at 2:14 PM / IP Logged

did you program for tach or voltage?

alan bindrup

Member - Posts: 3

Joined: November 17, 2009

Location: Utah, United States

Posted: November 19, 2009 at 5:41 PM / IP Logged

No tach input.

dasbogie

Silver - Posts: 514

Joined: September 30, 2006

Location: Pennsylvania, United States

Posted: November 19, 2009 at 9:14 PM / IP Logged

does your bulldog support shutdown diagnostics? if so check it. do you have a hoodpin hooked up? make sure it's not seeing ground when remtoe starting.

alan bindrup

Member - Posts: 3

Joined: November 17, 2009

Location: Utah, United States

Posted: November 19, 2009 at 9:28 PM / IP Logged

I haven't seen anything on shutdown diagnostics. Factory tech support is non-existent. Haven't hooked up the hood pin. I'm pretty sure that the module is sending the wrong type of signal to the computer to let it crank the starter. Ignition powers up, and shuts down, as it should. Just no starter crank yet.

Thanks

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

bulldog security

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.