dodge ram 2010 remote start

Good day all! I am installing a remote starter on my 2010 dodge Ram quad cab slt with a PKUMUX transponder override module. remote starter is a valet 561r. On xpresskit's site the PKUMUX is supposed to be standard application for my truck, however, when I look at the installation instructions, they refer to a 5 pin plug and a single Multiplex wire that I need to interrupt and connect to PKUMUX. All I could find on my truck was a 12 pin plug on the WIN. I got the pinout (from bodybuilder) and I don't see any Multiplex wire. All I have is a CAN C BUS + and a CAN C BUS -. Any help would be appreciated! Thank you ! Martin

Do you tave the "Tip start" key?

Or a regular metal key that goes into the igniton switch?

Ok, got the info, I've ordered the wrong module, since it's tip-start CAN type I need a CHALL instead, pkumux is for 2008 and older. Seems like the DEI website was wrong, and i'm stuck with a PKUMUX.. cheers Martin

Thats a good mudule.  I wouldnt consider yourself STUCK with it.

But yes, that was the wrong interface module for that vehicle.

Yes I agree that this is a very versatile module! I have few friends who own chryslers, i'll try to sell it to them! ;)

I wish they would have put a lock on the connector though

So be sure to put a wire tie aound the module to lock the connector in.