Saturn SL2 Wiring Help

Home / the12volt's Install Bay / Car Security and Convenience / Saturn SL2 Wiring Help (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

matto2002

Member - Posts: 10

Joined: April 02, 2003

Location: United States

Posted: April 19, 2003 at 3:56 PM / IP Logged

I'm trying to install a Crimestopper DC2003II on my SL2. I'm having problems finding the wires in the console for the door triggers and such. Can anybody help?

Matt

odie34567

Member - Posts: 4

Joined: April 19, 2003

Location: United States

Posted: April 19, 2003 at 6:00 PM / IP Logged

i'm trying to do the same thing i have a 95 Saturn SL2 i went to http://www.bulldogsecurity.com/wires2/pr_showmodels.asp?modelid=15229 it has somewhat of a wireing diagram and tells you to look for the wires to unlock it is a light blue in the center console behind fuse box, and the unlock is in the drivers kick panel it is white and both are +(pos.)

Odie

matto2002

Member - Posts: 10

Joined: April 02, 2003

Location: United States

Posted: April 19, 2003 at 6:10 PM / IP Logged

I have that same diagram for the 96, but I'm kinda confused, because I'm seeing several light blue and several white wires in there. Also do you by chance know anything about the door triggers? I can't figure out where that wire is for anything. All i can find are two groups of wires below the cig. lighter.

Matt

matto2002

Member - Posts: 10

Joined: April 02, 2003

Location: United States

Posted: April 19, 2003 at 6:11 PM / IP Logged

also, i don't want to sound stupid or anything, but the drivers kick pannel, is it the console that gives you access to the back of the fusebox, or is it the plastic trim on the drivers door side?

Matt

odie34567

Member - Posts: 4

Joined: April 19, 2003

Location: United States

Posted: April 19, 2003 at 6:17 PM / IP Logged

i think by the dr. side kick panel they mean where your left foot would be when your siting in the drivers seat what i'm going to do when i get home is where the relays for the locks are you can pull thet off when you move that metal bar out of the way and find the wires that go to those relays and test them with a probe.

Odie

matto2002

Member - Posts: 10

Joined: April 02, 2003

Location: United States

Posted: April 19, 2003 at 6:57 PM / IP Logged

That dosen't sound like a bad idea. Thanks for the help. Maybe I can finally get this thing figured out.

Matt

matto2002

Member - Posts: 10

Joined: April 02, 2003

Location: United States

Posted: April 19, 2003 at 7:01 PM / IP Logged

Do you happen to know anything about the door trigger wire that is supposivly under the ashtray? (White -)

Matt

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: April 19, 2003 at 7:24 PM / IP Logged

hey guys this info is for the 96. see if it will help...

Constant 12 volts RED & RED IGNITION SWITCH HARNESS

Ignition 12 volts PINK IGNITION SWITCH HARNESS

Starter YELLOW IGNITION SWITCH HARNESS

Dome Light WHITE (-) AT FUSE BLOCK IN DRIVER KICK PANEL *

Trunk Pin Switch RED / BLACK (-) AT LIGHT IN TRUNK

Parking Lamp BROWN (+) AT HEADLIGHT SWITCH OR FUSE BLOCK

Power Lock L BLUE DRIVER KICK #202

Power Unlock WHITE PANEL

#202- See Positive Pulse Door Lock Diagram. * WHITE Wire Can Also Be Found In Passenger Side Rear Body Harness Wrapped With Green Tape

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: April 19, 2003 at 7:26 PM / IP Logged

by the way make sure check all wires with a volt meter.

NOT A TEST LIGHT!

good luck.

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

matto2002

Member - Posts: 10

Joined: April 02, 2003

Location: United States

Posted: April 19, 2003 at 8:12 PM / IP Logged

Thanks for the info Dave. I have another question for you though. It only has one wire listed for the door trigger, but my alarm has 2 wires for the for the door pin hook up. I don't have my instruction manual to tell you exactly what they do. Any suggestions for this?

Matt

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.