2010 subaru legacy will not crank

Home / the12volt's Install Bay / Car Security and Convenience / 2010 subaru legacy will not crank (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

gearnut1979

Member - Posts: 3

Joined: November 03, 2010

Location: Massachusetts, United States

Posted: March 12, 2011 at 12:28 PM / IP Logged

Hi, I have a 2010 Subaru Legacy with a Viper 5701 unit installed.

Currently with a key the vehical will not crank. I have tested the battery and it was showing 12.3 volts. Just to rule it out I attached jumper cables, and it still did not crank. The dash light for oil temp flashes red then blue and strobes when the key is turned to the on position. The brake light was also blinking. There was not a check engine light or a code.

I have tried putting the Car in both park and neutral with the same results. All the fuses appear to be in good shape.

Prior to this event the car had zero issues starting with either the key or the remote start.

If anyone has an suggestions it would be greatly appriciated. Thank you very much for your time.

Thanks, Dan

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: March 13, 2011 at 4:14 AM / IP Logged

Main plug should have a green key side and violet starter side.

Check to see if you have voltage at both sides when you turn the key to the start position or continuity with everything switched off.

If you don't you have an internal relay failure on the unit. There is a work around but simply loop the green and violet together.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2010 subaru legacy will not crank

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.