I would like some help with the installation of the ProStart CT-3471TW remote starter with a DBAll module installed in a 2005 Mazda 3 Sport automatic. Currently I have it all wired and I am unable to program the DB-ALL. I have taken the wiring diagram from the DBAll as a reference in D2D mode and not connecting the leads from the remote start and the DB-All that were not indicated.
More info on the RS where you can find the install guide: http://www.autostart.ca/prostart/prod-en_CT-3400TW.php
More info on the DB-All where you can find the install guide: http://www.xpresskit.com/DocumentDownload.aspx?documentid=7086&productid=461&firmwareid=2464
I have the following connections made (soldered everything...):
From the RS
6 Pin Harness
A Red +12V -------> Red @ Ignition Harness
B Purple Starter Output ---------> Grey/Black @ Ignition Harness
C Red +12V -------> Red @ Ignition Harness
D Yellow Ignition Output --------> GREEN/ YELLOW @ Ignition Harness
E Orange Accessories Output ---------> Pink / YELLOW @ Ignition Harness
F Green 5th relay output -------------> N/C
1 Black Chassis Ground --------> To safe chassis ground
2 Purple Tach input -----------> N/C
3 Gray Hood Switch ---------> BLACK / YELLOW @ OEM hood switch connector under pass side glove box
4 Orange Brake Switch input ---------> RED / White @ Driver kick panel
5 Yellow Positive Parking Brake output -----------> N/C
12 Pin Harness
None are connected
1 Gray/Light Blue Aux2 -----> N/C
2 Blue/White Aux1 -----------> N/C
3 Yellow/White Negative Parking Lights Output ----------> BLACK/ White @ Driver kick panel
3 Tan/Black HSCAN High -----> ODBII connector pin 6
4 Tan HSCAN Low -------> ODBII connector pin 14
8 Violet/Green Door Lock MUX output-------> GREEN/ Red @ Driver kick panel
9 Violet/Brown Door Lock MUX output -------> same as above
10 Yellow/Black TX -------> Grey/Orange @ Ignition Switch
11 ORANGE / Black RX -------> WHITE/ Green @ Ignition Switch
9 Pink ignition input --------> GREEN/ YELLOW @ Ignition Harness
From here I tried to program the DB-ALL following the steps within the document for type 5 using a DBALL with firmware 401.Mazda v1.10.11. From the intructions since the Mazda is an automatic I have to start vehicule with the remote start although I did not manage to program the remote (more on this below) so I have tried to follow the manual transmission install procedure even though it is an automatic. All of the steps seem to go flawlessly but after step 6 the dball simply flashes red and nothing happens. From there I cannot go any further. I have tried doing this many times with the same results.
Trying to program my remote starter the unit doesn't seem to want to enter programming mode. I flash the hood pin for 4 secs and then on/off and the parking lights go on then immediatly off within 4 seconds. I have tried 2 remote starters and they both did the same without really entering the programming mode so I haven't been able to program the remote. The antenna is connected and I have tried all the steps included in the troubleshooting pages with the same result. I do not know if it is because the DB-All needs to be programmed first although from the instructions it seems to be dependent on the remote starter.
I have installed the same remote start with the dball in another vehicle with absolutely no issue although it did not require so much programming. If you can tell me what I am doing wrong that would be great.
Thanks in advance!