viper 5701 issues

Hey guys. I have a 2002 Chevrolet Trailblazer. I am installing my Viper 5701,I have the DBALL bypass module. I'm pretty sure everything is connected correctly but I could be wrong.        H1 Harness H1/1 to 12VDC H1/5 to ground H1/11 to parking lights H2 Harness H2/17to Brake H2/18 to ground (Haven't hooked up the hood pin yet) H3 Harness H3/1 to Pink H3/2 to Red H3/3 to Orange H3/4 to Yellow H3/6 to Red and White H3/7 to White H3/9 to Red The bypass module is working. The doors lock and unlock, hatch and window included. Horn honks and parking lights flash. My issue is the remote start when I go to remote start the vehicle it flashes or clicks 7 times. Which I know means that it is stuck in Manual transmission mode and needs to be reprogrammed to Auto Transmission mode. So I have tried these steps to do so: 1. Open car door. 2. Cycle ignition key ON then OFF. Do the next step within 10 seconds. 3. Press and hold valet switch until LED flashes 3 times (siren chirps 3 times), then release. 4. Press and release valet switch once then press and hold. Siren chirps once. 5. While still holding the valet switch, press UNLOCK button of transmitter. Siren chirps 2 times. 6. Release valet switch. Cycle ignition key ON then OFF. I get the chirps and lights on the "Valet switch" but when I go to remote start the vehicle it still flashes and clicks 7 times. Any idea what I am doing wrong? Thanks for the help guys.

Bulldog wiring shows this vehicle has two ignitions and two accessoriesWhen all else fails, Read the Instructions

Support the12volt.com Make a Donation

Sorry about that. This is what my H3 Harness looks like. I'm going to run out and try the programming again. I'll let you know what happens. -Also I was told I did not need the second Ignition wire for my car as it probably controls the radio H3/1 to Pink - Ignition Wire H3/2 to Red - 12VDC Constant H3/3 to Orange - Accessory Wire H3/4 to Yellow - Starter Wire H3/6 to Red and White - 12VDC Constant H3/7 to White - 2nd Ignition Wire H3/9 to Red - 12VDC Constant

Still no good. I did what you said waited after pressing the unlock button on the Viper fob and after about 30 seconds it sounded. I went On to off and still I get 7 flashes. I also noticed that when I push the unlock button it chirps once then I have to press it again ,where it then chirps twice.

@smokeman1 I got it. What it ended up being was I was not in the actual program mode to get it into Auto Transmission mode. I read another post that you helped someone else out with and saw that he said he wasn't actually in. I too was hearing 3 total chirps but not realizing that I actually needed to keep holding it until it chirped 3 times quickly back to back. Thanks for your help. Now to button it all up.