tacoma python alarm

Hello I just install a Python 574 in a 2013 Toyota Tacoma..all is working well.but... When I remote start..many ligh in the instruments panel still on..after I introduce the key in the lock all became normal only the air bag icon still on..what wrong? a bad connection? Thanks Raul

Have you connected both the ignition wires?

Does the air bag icon come on when you simply use the key?

Hello Yes . both ignitions are conected..I didn't use anti-grid relay Thanks Raul

Hello Air bag icon still on when I use key after remote started .If i unplug H3 conector from the main module..and start with the key..all is normal. I didn't use any diode or relay in my conection.. Thanks Raul

Please list your wiring, H3 to car.

Hello again Here is the wiring H3-1 Pink        to BLACK/ Red (Ignition 1) H3-2 RED / White    to Not Connected H3-3 Orange       to WHITE/ Green (Accessory/Heating blower) H3-4 Violet       to GREEN/ Black and BLACK/ White (Starter 1 and 2) H3-5 Green        to Not Connected H3-6 Red to WHITE/ Blue (12 volts Constant 50A ??) H3-7 Pink/White   to Blue / YELLOW (Ignition 2) H3-8 Pink/Black   to Not Connected H3-9 RED / Black    to WHITE/ Red (12 volts Constant 30A) H3-10 n/a Thanks Raul

OK H3/2 RED / White That's one reason for the warning lights it won't start CONNECT. Starter one, cut key side to H3/5,GREEN. Starter side to H3/4 Violet. Starter 2, use a relay and a diode (1N4004)as per the diagram:- tac_2nd._starter.bmp Diode use is MANDATORY to protect your R/S. Wiring the two starters together as you've done is inviting trouble and expense down the road. Why do you think some car manufacturers split those circuits? And that's probably the second reason.

When all is done you will probably need to get the airbag warning light cleared.

Tacoma airbag light will go out if you disconnect the battery for 1 minute.Mike M2

Tech Manager

CS Dealer Services