'09 Nissan Rogue remote start issues

Home / the12volt's Install Bay / Car Security and Convenience / '09 Nissan Rogue remote start issues

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

armbruster

Member - Posts: 32

Joined: March 13, 2003

Location: Kansas, United States

Posted: November 14, 2015 at 7:20 PM / IP Logged

I put a Viper 4115V on a 09' Rogue using a DBALL2 and firmware 402.NISS2HT v3.07 using D2D. (Intella key)

Install went well and car started fine. Customer took it home and it stopped working a day later. No response from the unit when she pushes the button on the remote. No shut down messages or attemp by the RS to start.

I replaced the unit and the DBALL2 to just eliminate any chance of a bad unit and system worked fine for 2 days - now not working again. If you disconnect the unit and reconnect it will work fine for a short period and stop again.

I am at a loss as to what is happening. Any ideas or anyone ran into this?

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.