Diode isolate a PAC TR12

Home / the12volt's Install Bay / Car Security and Convenience / Diode isolate a PAC TR12

Welcome Guest :)

Members

< Prev Topic Next Topic >

tdbaker021

Copper - Posts: 98

Joined: November 27, 2016

Location: Tennessee, United States

Posted: January 23, 2017 at 8:52 PM / IP Logged

Can you diode isolate the output wires on a PAC TR-12? I want to use the TR12 along with my DEI 530t. I want to connect 3 of the TR12 output wires to the DEI 530t orange wire. The GWA, channel 3, and the proximity pre-warn sensor from the alarm will connect to the PAC TR12 inputs. The 3 outputs will connect to the DEI 530t orange wire (with diodes) to roll the windows up when the system is armed, ch 3 is used or the pre-warn from the proximity sensor is activated.

tdbaker021

Copper - Posts: 98

Joined: November 27, 2016

Location: Tennessee, United States

Posted: January 24, 2017 at 12:42 AM / IP Logged

tdbaker021 wrote:

Disregard this post. after reading more on the TR12 I can use the 3 inputs and one output connected to the 530t orange wire...

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.