must hold down button to arm/lock?

Home / the12volt's Install Bay / Car Security and Convenience / must hold down button to arm/lock? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

mista2turbo

Member - Posts: 4

Joined: September 01, 2003

Location: United States

Posted: September 01, 2003 at 7:42 PM / IP Logged

I am in the process of installing a Clifford Matrix 3. I have to hold down the button to arm the system and lock the doors. The unlocking/disarm works normally with just a single press of the button. Any ideas/suggestions?

jaxman

Copper - Posts: 185

Joined: November 16, 2002

Location: Denmark

Posted: September 02, 2003 at 4:53 PM / IP Logged

Check the antenna wire.Check also the ignition.I think some wire keeps sending +12V after the engine it is off. Had this problem twice.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

must hold down button to arm/lock?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.