2003 chrysler town and country starter

Home / the12volt's Install Bay / Car Security and Convenience / 2003 chrysler town and country starter (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

bmf1000d

Silver - Posts: 345

Joined: September 30, 2003

Location: United States

Posted: January 09, 2004 at 2:25 PM / IP Logged

im haveing trouble with the engine starting. It cranks over but it does not start. I have the relay wired for the 180 ohm negative for the 2 starter wire. I was wondering if that could be possibly a ingintion wire and not a start wire. Any information you have would be helpful...

"Big" Mike

Double Take

Fremont, Ne

remember to check all your wires with a dmm not a test light!!

i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: January 09, 2004 at 2:35 PM / IP Logged

Make: Chrysler

Model: Town & Country (Van)

Year: 2002-03

This Database Was Last Updated On: 6/9/2003

Index #: 5820

Alarm

Constant 12 volts L BLUE IGNITION SWITCH HARNESS *

Ignition 12 volts PINK/WHITE IGNITION SWITCH HARNESS **

Starter YELLOW (+) IGNITION SWITCH HARNESS

Dome Light YELLOW/WHT (+) PIN 33 OF 34 PIN CONN. AT B.C.M.

Trunk Pin Switch VIOLET/ORANGE (-) PIN 29 OF 34 PIN CONN.AT THE B.C.M.

Parking Lamp WHT/BRN(RESISTOR SYS.) AT HEADLIGHT SWITCH (SEE TECH NOTES)

Power Lock VIOLET/D GREEN AT B.C.M.LOWER LEFT OF STEERING ***

Power Unlock SINGLE WIRE SYSTEM COLUMN IN PIN 21 WHT 34 PIN CONN.#217

* All Wires Are 20 Gage.L BLUE Fused At 10 Amps. For main Power Connection Connect To BROWN / RED Or WHITE/ RED Fused At 20 Amps At 6Pin Conn. At B.C.M. ** Ignition Wire Controls All Accessories. *** Chassis Ground Thru A 5.3k To Lock And Chassis Ground Thru A 2k Ohm Resistor To Unlock. ( Connector Is Third Up From Bottom Of BCM) #217-See Single Wire Resistor Door Lock Diagram

Remote Start

Tach Signal D BLUE/D GREEN PIN 11 GRAY/BLACK 40 WAY CONN.P.C.M.*

Ignition #2 See Note Below **

Ignition #3

Accessory

Neutral Safety WHITE/ LT GREEN PIN 9 OF 34 PIN CONNECTOR AT BCM

Brake Light WHITE/ TAN (+) AT SWITCH

Reverse Light WHITE/ LT GREEN (+) PIN 9 OF 34 PIN CONNECTOR AT BCM

Rear Window Defrost

* Power Control Module Located Left Front Corner Of Engine Compartment. Ignition Input To Keyless:PINK/WHITE ** VIOLET/BROWN and VIOLET/ORANGE Must See 180 OHM Resistor Between Them During Start Due To Multiplexing. #239 - See Immobilizer Bypass Diagram.

if you are using an omega product...here is the number for them:

1-800-554-4053

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

bmf1000d

Silver - Posts: 345

Joined: September 30, 2003

Location: United States

Posted: January 09, 2004 at 2:56 PM / IP Logged

Still dont start. it will start with the key but not the RS. I dont have a violet/orange wire all i have is the viol/brn and thats it...

"Big" Mike

Double Take

Fremont, Ne

remember to check all your wires with a dmm not a test light!!

i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: January 10, 2004 at 1:47 PM / IP Logged

how did you make out on the remote start?????

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

bmf1000d

Silver - Posts: 345

Joined: September 30, 2003

Location: United States

Posted: January 10, 2004 at 11:56 PM / IP Logged

Still did not work so im gonna tackle it on monday with a fresh start

"Big" Mike

Double Take

Fremont, Ne

remember to check all your wires with a dmm not a test light!!

i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof

denis mcginn

Member - Posts: 6

Joined: December 26, 2003

Posted: January 11, 2004 at 9:58 AM / IP Logged

I think you need to create both crank and run resistance circuits at the ignition switch sense wires to the bcm. this is what I had to do on 02 caravan, but unfortunately I dont remember the resistance values. You can measure at switch to get proper values of the crank and run. poss two violet wires. I think the values are 180 ohm and 300????

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2003 chrysler town and country starter

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.