95 s15 jimmy aftermarket alarm

im hooking up an alarm, just need a little help with the wiring diagram. got the diagram off this site but doesnt have everything. still need the hazard lights, open dormer??, engine cap??, siren, ignition coil, ignition key switch, negative door switch, positive door switch, and the main light. only got 6 out of 18 from the diagram here. thanks for any help ahead of time.

Are you sure you need to hook all that stuff up? That's a lot of work for just an alarm? DIRECTWIRE™ WIRING INFORMATION - GMC / JIMMY / 1995 / Security 12volts red    +   ignition harness Starter purple or yellow    +   ignition harness Ignition pink    +   ignition harness Power Lock lt. blue    +   either kick panel Notes: Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function. Power Unlock white    +   either kick panel Notes: Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function. Lock Motor gray      drivers kick panel Unlock Motor tan      drivers kick panel Disarm Defeat tan      passengers kick panel Parking Lights+ brown      switch or rear harness Parking Lights-           Hazards           Turn Signal(L)           Turn Signal(R)           Door Trigger white    -   keyless module Notes: Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function. This wire cathes all doors, but reads the delay. To keep the alarm from reading the delay, place a diode in-line on the white door trigger wire with the anode towards the keyless module. Attach your door trigger wire to the cathode side of the diode. On non-keyless models the is a module with 5 wires located where the keyless normally resides. The white wire there catches only the front two doors. To catch the rear doors use the white wire at the drivers side rear pin switch. Dome Supervision use door trigger        Trunk/Hatch Pin tied in with doors        Hood Pin           Trunk/Hatch Release BLACK/ white    +   switch or keyless Notes: Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function. Power Sliding Door           Factory Alarm Arm           Factory Alarm Disarm           Disarm No Unlock           Tachometer white    AC coil on top of engine Horn Trigger black    -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Immobilizer Bypass Module: Required: No Type: N/A Part #: N/A Notes: N/A        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.

thanks for the wiring codes. i thought it was alot of wires to hook up for an alarm too, but im guessing because its an alarm, keyless entry, power windows up/down, and door opener system that it needs them.