Varad Led to an existing Viper Led

Home / the12volt's Install Bay / Car Security and Convenience / Varad Led to an existing Viper Led (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

rcgait1

Member - Posts: 8

Joined: April 29, 2005

Posted: May 02, 2005 at 11:11 AM / IP Logged

I have the Viper 791 and I want to add a Varad Led scanner to the existing system led. I was hoping that all I had to do was add the new scanner to the exisiting led. Is this possible? The way the existing led is set up is that it has a blue and a red wire but from research the Varad has 3 wires ( red, black and yellow). Is it possible to tap into the existing led basically in a series? If so what wires need to be tapped into what? Any help would be appreciated.

desh187

Copper - Posts: 310

This member has made a donation to the12volt.com. Click here for more info.

Joined: September 13, 2002

Location: Canada

Posted: May 11, 2005 at 6:08 PM / IP Logged

red wire is 12 volt,black and yellow can go together to ground output when armed wire from alarm(starter disable wire).

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Varad Led to an existing Viper Led

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.