command start and alarm

hi there, had a question about the 290i-c and a ultrastart 600 alarm. just wondering if it is posible to wire the command start so that it will opperate off the alarm or vice versa. i have done it in the past with some different models but I cant seem to find any way in the install manuals to do it with these two models.

Thanks for looking guys, but i think i figured this out my self. im going to take the negitive output for the trunk off the 600 and connect it to the yellow (tempature sensor enable) off the command start. go into the command start settings, turn on temp sensor and presto. I should be able to turn on the car with the alarm remote. hope it works, ill get back to you with the results.

one more quick question. does the low temp sensor need a high or a low to start?

The YELLOW wire requires a .5 second (-) pulse to activate the starter sequence. First try using the trunk release and see if the wire is strong enough for the CS to recognize a (- signal. OTherwise, use a relay.Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

It works..... one remote, for alarm and starter. heading home tonight to hook up the actuator in the driver side door (93 mx6) and it is complete. didnt need a relay, the alarm will enable the command start just fine. thanks for all the help.