Chevy S-10 Power Lock

I am in the process of installing the stock power switches for my Chevy S-10 2002, simillar to http:///.com/ebaymotors/POWER-WINDOW-SWITCH-CHEVY-S10-S-10-BLAZER-JIMMY-TRUCK_W0QQcmdZViewItemQQcategoryZ33696QQihZ011QQitemZ320022397229QQtcZphoto

Except I only have a two door vehicle. I installed a central locking power door keyless conversion kit about a year ago, and now I wanted to upgrade to the stock swtiches so I can control the windows and door. I have succesfully wired the windows, however, I am having a lot of trouble with the power door locks.

The unit I installed is:

http:///.com/ebaymotors/Auto-Car-Alarm-Central-Power-Lock-2-4-Doors-Door_W0QQcmdZViewItemQQcategoryZ33721QQihZ017QQitemZ270033792047QQrdZ1

There are 5 wires going to the driver's side accuator: Blue, Green, WHite, Brown, and Blacks; and only two going to the passenger side accuator: blue and green. They are run back to the central keyless module that came with the kit, where there are two wires that I have never used in the past year that when I installed it the installation papers said that were for the switches if you had them

I used a Voltmeter and saw that either the brown or white wire always have +12 V in one of the wires, when I either use the keyless remote or the central lock feature to change the lock or unlock status, the 12 V charge cahnges from the brown and white wire.

The black wire from the central keyless module is charged +12V when I press the lock on the keyless fob. When I ground that wire, the locks go to "unlocked." However, the red wire that is suppose to go to the other switch wire doesn't energize or do anything. I thought that it would get charged and when I ground that the lock should lock.

I am not sure what I am doing wrong. I am very confused and would just like to fin dout how to connect my chevy s-10 stock power door swtich to this crappy keyless module.

Any help is greatly appreciated!