help with a keyless entry system..

I am putting in a DEI 711T keyless entry system in a 94 mercury villager

I was wondering what exactly the lock and unlock motor go to and where the door trigger hooks up to. Im thinking the lock and unlock moter go to the common #30 on the 8 pin connector??  Also not really sure what wire in the car is for the domelight?

 These are the wires from the brain and where i think they go

Thanks for the help

on the tech sheet it says grounded at rest thru dash ind. - use diode to isolate. RED / black (-) wire in the drivers A pillar is the domelight output from timer. Gets all doors but reads delay. There is also a blur (-) in the center console that catches all the doors on keyless models.

also do i use the door trigger wire if so where do i hook it up to on the brain??

You don't need door trigger if you're only doing keyless entry.

But if you want the domelight to come on when you unlock the doors, tie the wire labeled as 2/b to a ground, and tie the 1/4 wire to the negative side of any courtesy light in the car......if there's an underdash courtesty light, (which most Nissans don't have though), that'd be the easiest place to get it.  You'll probably be best to get the RED / black at the A-pillar.

so the lock motor and the unlock motor go to the commom #30 wires on the brain correct??

I do want the domelight to come on so do i hook up the RED / black wire in the A piller to the domelight on the brain??

use a relay for the domeligth,because the current from the brain is not to strong.and yes to the other question.