2006 ford fusion remote start problems

ok the problem is if i try to remote start the car its accesory,parking lights ,go on then it engages(starter)( for less than a second then shuts off ,and in order for me to try again i have to put the factory key in ,start it then shut it off to try it again ,it has a factory alarm but everyone ive talked to said it wouldnt matter,ive checked neutral safety,brake and all the heavy gauge wires any help would be great

is the security light in the car coming on solid then going out or is it flashing? what kind of remote starter and bypass did you use?Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

flashing,and im using a 556u

i connected the tach onto the purple wire next to the gray one ,it cranks but only for less than a sec then shuts off ,is it safe to change cranking time or voltage sensing?

If the factory security light is blinking when it tries to remote start it isn't reading the key inside the 556UW. It should go solid then turn off. Try putting the key directly into the ignition without turning it and remote starting the car. If the car starts you know for sure that is what it is.Mike M2

Tech Manager

CS Dealer Services

just tried it still nothing acts like its gonna start then shuts off imeadiately,imm ready to rip it out soon been messing with it for way to long any more suggestions

if the factory security light is flashing when you try to remote start it then your 556u isnt hooked up right or the ring isnt in a good spot on the cylinder for it to read. i would definetly start there. try moving the ring etc.

I hated using those ring things. You may want to try a xk04 from bypasskit. It will act like a key but not have to worry about leaving a key under dash. Use both keys in ignition then try to start that is programing of xk04. Try using voltage sense for remote start. I know it is not as accurate but it still works on some cars you have an issue with finding the correct tach wire.The wire I'm test'n isn't doin' what it's supposed to be doin'... I am so glad I printed that tech sheet, with the wrong info.

Do it right the first time... or I might have to fix it for ya

i dont have the car here right now but ,i think it goes offwhen trying to start,i also put the key in then try it same thing ,but whats weird is in order to try re starting it i must put factory key to accesory then back off in order to even try remote starting ???