If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.
Printable version

| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Follow the12volt.com
Saturday, October 25, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Saturday, October 25, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.





Center module:
Wiper/brights switch
Headlight switch:
Ignition harness:
OBD:
I'm going to start by soldering:
[RED 12VOLT 30AMP ALARM INPUT] to the [SOLID RED IGNITION HARNESS]
[SOLID BLACK SYSTEM GROUND INPUT] to [VEHICLE CHASSIS]
now I must figure out which reference to use for the door trigger either it is [PURPLE (-) HEADLIGHT SWITCH] and/or [BLACK/ORANGE DRIVER KICK PANEL]
and which+what reference for the horn wire either [Horn Dark Green (-) Driver's Kick at Relay or at Pedal] or [HORN BLACK (-) @ STEERING COLUMN HARNESS]
Anyone familiar with it?



