spacer spacer spacer spacer

1996-97 Ford Crown Victoria Cruise Control Wiring

Vehicle Search Manufacturer
Select Vehicle Manufacturer
If you do not find the vehicle information you're looking for here, please post your request here. We will NOT respond to any requests by email.

Please do not copy and paste this table into your forum posts. Please copy and paste the link below instead:
1996-97 Ford Crown Victoria Cruise Control Information )

1996-97 Ford Crown Victoria Cruise Control Wiring Information
Constant 12V+ Yellow or Green  Ignition Switch Harness or Use Hot Side of Brake
Switched 12V+ Brown/Pink  Ignition Switch Harness 
Ground Use Chassis  Near Cruise Control Module 
Hot Side of Brake Light Green/Red  Brake Switch or 16 Pin Connector Driver's Kick 
Cold Side of Brake Light Green  Brake Switch or 16 Pin Connector Driver's Kick 
Tach Tan/Yellow  ICM Module, 2 Cylinder Setting 
VSS Wire Gray/Black  10 Pin Harness, Driver's Firewall, Pin 3 
Pulses Per Mile 8000 PPM 
Notes: Vehicles with Manual Transmission require Clutch Switch. Some vehicles may require a speed signal generator and/or other parts/adapters not listed above. Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.

Follow Follow on Facebook
Saturday, July 13, 2024 • Copyright © 1999-2024, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo spacer spacer spacer
Top spacer spacer