99 Durango/Ungo MS2007 install

I am installing a Ungo MS2007 into my 99 Durango and have some questions. First, I can not find my blk/gry tach wire, I know it is located at the coil yet I can not find it. Could someone tell me exactly where to locate it(origin, wire housing,etc.)? Second, the MS2007 installation manual doesn't explain how to hook up it's door lock module it comes with. It comes with both the lock/unlock wires, and or the door lock module. Could someone explain that install, or post the diagram? Thanks

the pcm is on the right inner fender it is in in the c1 connector or you can use an injector wire. not sure of the ungo locks however.

Thanks, I found the blk/gry tach wire, however when the remote starter starts the engine it still doesn't recognize its on and shuts off. Any ideas?

I've never installed an Ungo remote start, but most units make some kind of response when you program the tach rate...did the Ungo make the same response as the instructions indicate that it should? There could be two different lock systems on a Durango...does your have factory keyless entry?