DEI Wire Diagram Question

I was looking for information on a 94 Nissan Altima and I ran across a post. At the bottom of the post it said: "Notes: *1 When doing remote start, this wire must be isolated from the keyswitch with the accessory relay. See direct fax document #1077." (It is referring to an accessory wire) Doesn't the relay make it isolated? Is there something else I'm going to need to do? Anyone have any idea what is on Directed fax document #1077? Thanks in advance!"Drive it like you stole it"

You Need you disconnect accessory wire from Ign swtich when it's runing by remote starter..use one relay... Cut Acc wire in car Ign side goes to 87a of relay,Car side will go to Pin#30 ,87 and 86 connect to 12 Volt 85 goes to DEI Orange wire from ribbon harness , Also you can do just connect Another wire to Supplied Relay Pack on acc realy at 87a and goes to Ign side and car another side goes to Orange form relay(still need to cut acc wire in Ign)