06 dodge ram door trigger

On that particular truck you can go directly at the cluster for al the door triggers of you have to go directly to each of the door grommet leading inside of the car. Then diodes each door cutting in between the bcm and the actual door trigger.

LF door is purple

RF door is purple white

LR door is PURPLE / orange

RR door is tan / YELLOW

Looks like you might be using the actual domelite trigger that is why you are having problems. Use the wires I listed and you should be good to go.

Also there is a total of 8 diodes not 4.

;these are the wire I used at the cluster but I  only use 4 diode I did not know I had the use 8 that might be why! This is good info thanks but it working fine with pos door trigger @ doom light works on all doors alarm goes off when door is open and the big thing is It does not go off 2 min after I set it!!

P.S. how do you hook up neg trigger using 8 diodes just in case I start having problems with the way I have it hooked up now

If you already wired up the 4 diodes between each door than the other 4 you will parallel all 4 going into the alarm system but make shure you tap the door switch side not the bcm side.

if you tap the pos door than you have the delay door chip. I don't work with compustar so I don't know how the system works. If you followed and tested your wires correctly than you don't need to use the pos domelite wire and plus too sometimes if you use the domelite as a trigger you will have falsing problems when the bcm shuts down.