07 tacoma remote start wiring

PASSIVE ANTI-THEFT YES TRANSPONDER    SEE NOTES    Standard on Tacoma 3.4L V6 models. If using a key for bypass, see the provided diagram for wiring instructions. 12 VOLTS WHITE/ blue Ignition switch harness    + IGNITION Blue / YELLOW Ignition switch harness    + IGNITION 2 BLACK/ red Ignition switch harness    + ACCESSORY Runs with ignition wire        STARTER BLACK/ white (AUTO TRANS)Ignition switch harness (MANUAL TRANS)BLACK / YELLOW @ clutch switch    + (BLACK/ white is not needed on trucks due to the clutch switch) STARTER 2 GREEN/ black Ignition switch harness    + KEY SENSE GREEN/ black Ignition switch    - TACH SIGNAL BLACK/ white At diagnostic plug below driver's side dash    AC FUEL INJECTOR Opposite from BLACK/ red At any injector on engine    AC LOCK Violet On white connector in driver's kickpanel    - UNLOCK GREEN/ black (double pulses) On white connector in driver's kickpanel    - DOORPIN GREEN / WHITE In 26-pin plug on module connected to fusebox under dash    - FACTORY ARM Arms with lock wire        FACTORY DISARM Disarms with unlock wire        BRAKESWITCH Blue At switch above brake pedal    + PARKLIGHTS Green In 13-pin plug on left of fuses on fusebox under dash    + PARKLIGHTS (-) Green Light switch harness    - HAND BRAKE GREEN / WHITE At switch on handbrake lever    - HORN GREEN/ red In 13-pin plug at right of fuses on fusebox under dash    - CLUTCH SWITCH BLACK/ white At switch on top of clutch pedal    TYPE 1 DRIVER WINDOW UP Blue / YELLOW At master window switch    REV POL DRIVER WINDOW DOWN Blue/green At master window switch    REV POL PASSENGER WINDOW UP RED / black At master window switch    REV POL PASSENGER WINDOW DOWN RED / green At master window switch    REV POL HEADLIGHTS RED / blue or RED / green At light switch harness    - REVERSE LIGHTS RED / black In driver's kickpanel    + DIMMER WHITE/ green At harness behind dimmer switch    + VSS WIRE GREEN/ orange At ECM behind glovebox          The GREEN/ ORANGE vss wire is located on the ECM behind the glovebox. On the 2.4L and 2.7L, it's at pin-8 of the 22-pin connector. On the 3.4L, it's at pin-12 of the 28-pin connector.

Hope someone is getting some use out of this.