DEI 507m Tilt Sensor issues

Home / the12volt's Install Bay / Car Security and Convenience / DEI 507m Tilt Sensor issues

Welcome Guest :)

Members

< Prev Topic Next Topic >

periziv22

Member - Posts: 10

Joined: February 25, 2016

Location: New Jersey, United States

Posted: May 28, 2016 at 3:42 PM / IP Logged

Hello,

I installed a DEI 507m tilt sensor on my truck and fallow the instruction carefully.

*the blue wire is connected to the instant trigger and diode insulated

*the orange wire is connected to ground when armed and also diode insulated

*the red wire gets 12V 1 Amp constant.

about 10 second after arming the alarm, the sensor sets off the alarm.

does anyone have idea what is wrong?

Thanks

Ziv22

periziv22

Member - Posts: 10

Joined: February 25, 2016

Location: New Jersey, United States

Posted: May 28, 2016 at 3:43 PM / IP Logged

2000 Durango V8 4.7L

Ziv22

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: May 29, 2016 at 4:30 AM / IP Logged

Leave out the diode to orange unless it's fulfilling another function.

Two diodes on the blue instant trigger if it's being used, also bands on diodes away from alarm.

periziv22

Member - Posts: 10

Joined: February 25, 2016

Location: New Jersey, United States

Posted: May 29, 2016 at 9:45 AM / IP Logged

Thanks for your replay,

I do have other functions on the AWG wire so i have to leave the diode (bends facing the alarm)

now, you say that i should add another diode on the blue line going from the tilt sensor to the alarm with the bend facing the tilt sensor?

Ziv22

howie ll

Pot Metal - Posts: 16,466

Joined: January 09, 2007

Location: United Kingdom

Posted: May 29, 2016 at 9:48 AM / IP Logged

All the bands should face AWAY from the alarm. Diodes are required to separate the signals.

If that blue wire fulfils another function, say trunk trigger, then use a diode. If not no diode required.

periziv22

Member - Posts: 10

Joined: February 25, 2016

Location: New Jersey, United States

Posted: May 29, 2016 at 9:54 AM / IP Logged

There is already diode on the blue wire that goes from the sensor to the alarm (facing away)there is other functions on the blue wire and they all diode insulated....

this is why i cant understand why the tilt sensor sets off the alarm 10 seconds after arming.

Ziv22

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.