Craig amp wiring

Home / the12volt's Install Bay / Car Audio / Craig amp wiring (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

nosnoggin18

Member - Posts: 8

Joined: March 07, 2004

Location: United States

Posted: March 09, 2004 at 9:22 AM / IP Logged

Yes, The power light comes on when I turn on the radio, and the "protection" light blinks on once then turns off.

I believe I have 4 RCA outputs in the back of the head unit, and 2 RCA inputs in the amp. It is an aftermarket head.(Sony Xplod)

Clean Install

Silver - Posts: 446

Joined: January 03, 2004

Location: United States

Posted: March 09, 2004 at 7:27 PM / IP Logged

I would run rca's from your rear output to the amp and then see if you have anything....you will lose your fading and balance control though

If we learn from each success and

each failure, then we can improve ourselves

nosnoggin18

Member - Posts: 8

Joined: March 07, 2004

Location: United States

Posted: March 10, 2004 at 3:56 PM / IP Logged

Hey, Thanks to all who gave advice to me on this topic. I did get the amp hooked up and it's sounding great. I actually found the diagram on the back of the amp-duh! I had my cousin come over and help me. He said he's been into stereos for 15-20 years.

One quick question-About the highlevel inputs-the diagram says that I hook up to the positive terminals on whatever speakers I use, and the other two wires go to the car stereo ground. Shouldn't the negative terminals be hooked up too? Probably a stupid question, but....

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Craig amp wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.