the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

94 Acura Integra alarm wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
kustomizer 
Member - Posts: 5
Member spacespace
Joined: September 19, 2004
Location: United States
Posted: September 19, 2004 at 8:00 PM / IP Logged  

Hi I am installing an Otion car alarm in a 94 Acura Integra.  The alarm calls for input power from the hazards and the alarm also has 2 input wires for that and I was wondering if anyone can help me on that and also where does the wire that says dist. go and if anyone can help me with this it would be appreciated greatly. If the door locks are neg.  do i need the 2 relays for this? I am not an expert at this and any help is greatly appreciated.

thanks-kustomizer

Teken 
Gold - Posts: 1,492
Gold spacespace
Joined: August 04, 2002
Location: Aruba
Posted: September 19, 2004 at 8:16 PM / IP Logged  
Acura
Integra
1994-1995
Remote Starter Wiring Colors and Notes
Function
   Vehicle Color
Location
Start:
   BLACK/ WHITE
IGNITION SWITCH HARNESS
Ignition #1:
   BLACK / YELLOW
IGNITION SWITCH HARNESS
Ignition #2:
   YELLOW
IGNITION SWITCH HARNESS
Ignition #3:
   N/A
Accessory:
   WHITE/ BLACK
IGNITION SWITCH HARNESS
Brake Light:
   GREEN / WHITE (+)
AT SWITCH ABOVE BRAKE PEDAL
Tach Signal:
   BLUE
AT DISTRIBUTOR*
Parking Lights:
   RED / BLACK (+)
GREEN CONNECTOR AT FUSE BOX**
Headlights:
   RED / WHITE (LO)
RED / BLUE (HI) AT HEADLIGHT SWITCH (+)
OEM Alarm Disarm:
   N/A
OEM Alarm Arm:
   N/A
Diesel Glow Plug:
   N/A
N/A
Clutch Bypass Wire:
   N/A
N/A
Notes:
   * Distributor Located On Passenger Side Of Engine. Tach Test Connector Is a 2 Pin GRAY Connector Located On Driver Rear Of Engine On Strut Tower. Tach Wire Also Located In 16 Pin GRAY Connector Above Fuse Block Behind Driver Dash.
--------------------------------------------------------------------------------
Acura
Integra
1994-1995
Alarm and Keyless Entry Wiring Colors and Notes
Function
   Vehicle Color
Location
Constant +12 Volts:
   WHITE
IGNITION SWITCH HARNESS
Starter Kill:
   BLACK/ WHITE
IGNITION SWITCH HARNESS
Ignition +12 Volts:
   BLACK / YELLOW
IGNITION SWITCH HARNESS
Dome Lights/Superv:
   LIGHT GREEN/ RED (-)
BLUE CONNECTOR AT FUSE BOX
OEM Horn:
   BLUE/GREEN (-)
AT RELAY ON LEFT SIDE OF FUSE BLOCK
Power Lock:
   BLACK/ WHITE
IN LARGER OF 2 GRAY CONNECTORS***
Power Unlock:
   BLACK/ RED
BEHIND CRUISE MOD IN DRIVER KICK PANEL
Trunk Release:
   N/A
Alarm Input Wire:
   LIGHT GREEN/ RED (-)
BLUE CONNECTOR AT FUSE BOX
Notes:
** RED / BLACK (+) In 18 Pin BROWN Connector In Driver Kick Panel Can Also Be Used For Parking Lights. *** See Note #201- Negative Pulse Door Lock Diagram.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, June 15, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer