Finding a power source when motor is run

Home / the12volt's Install Bay / General Discussion / Finding a power source when motor is run (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

SierraP615

Member - Posts: 5

Joined: November 16, 2004

Posted: November 16, 2004 at 11:40 PM / IP Logged

i say tap the oil pressure sensor

http://www.automotiveforums.com/vbulletin/showthread.php?p=2473365

Back to Top

overworked

Copper - Posts: 133

Joined: November 09, 2004

Location: Australia

Posted: November 17, 2004 at 1:49 PM / IP Logged

isn't the oil pressure snsor a variable volt wire depending on the pressure?as the pressure climbs the volts go down?

Back to Top

SierraP615

Member - Posts: 5

Joined: November 16, 2004

Posted: December 07, 2004 at 12:40 AM / IP Logged

sorry, a sensor is variable, as for a gauge

a sender, as most cars have, is a simple on/off pressure switch, set around 3 PSI IIRC, as for the low pressure light.

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Finding a power source when motor is run

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.