1996 Subaru Legacy wagon, Lock wire ?

iv installed the alarm the only thing not working is the locking of the doors.. the table on this site says the WHITE/ red is the lock wire but it doesnt work only the white wire for unlocking works please help is there a wire i need to cut so the WHITE/ red wires will work ? or is there some sort of relay i need to add-on or perhaps locating the central lock module which i have no idea where that is...

how are you making your connections? t-taps, or what? the WHITE/ red is the correct wire.and you say that it unlocks okay?jmacf14

yea its a tap to the lock WHITE/ red wire doesnt seem to work it only works for the unlock white wire any suggestions

Yeah if you're using ttaps... Don't.  Splice the wires.Cause I'm So white and nerdy...

First Class Certi-fried installer

I would solder all of your connections, that will probably fix your problem!jmacf14

but why isnt it locking the door am i tapping the wrong WHITE/ red lock wire? the white unlock wire was at the kicker panel the WHITE/ red wasnt on the same connecter harness so i just tapped the white unlock wire of the door connector that leads out to the side of the car to the drivers door, the WHITE/ red was on another connector i used a meter to test WHITE/ red lock wire no values showed up. where is the WHITE/ red wire suppose to be? .. so annoying everything but the lock works.. the keyless still works unlock/lock.. just need to fine that lock wire for the alarm.