scytek, releys

I'm putting the finishing touches on my alarm rs and, I have ran into something that's kind of wierd. The alarms trunk output wire is gray(aux1) and WHITE/ red is the aux2. Okay I have wired my relay like this 87 to car trunk wire(+) 86 to grey wire alarm(-) 85&30 to 12v(+) My question is the aux2 pops the trunk fine but the aux1 will not pop trunk,What am I doing wrong.?

test to see if aux 1 works. the relay setup is correct.

Could u share how to do that?

grab your volt meter. connect red to constnat 12volts and take the black and connect taht to your aux. hit the aux and it should read 12 - 14.4 volts. if there is nothing, it might be that aux 1 is optional for programming. or you fried the output.

no no no. your aux 2 output is for your trunk release. You have to hold that button for 3 seconds for the trunk lid to open correct? The aux 1 output is for stuff like a window module and is factory programed differently. If you want to use aux 1 though, look in your manual and it will tell you how to reprogram aux 1. Which alarm you have?

Aux 1 on any Scytek should operate the trunk release, unless you've programmed a custom button configuration. Are you holding the button for several seconds?C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two

yea  i got that backwards. thanks for clearing that up Chris.