rf t10001bd

Home / the12volt's Install Bay / Car Audio / rf t10001bd (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

michael213

Member - Posts: 34

Joined: May 20, 2007

Location: United States

Posted: January 03, 2008 at 8:29 PM / IP Logged

IDoes any one know what kind of wire goes from the amp to the PPB1 controller for this amp? I think it is normal networking cable but unsure. Any one know for sure?

Back to Top

michael213

Member - Posts: 34

Joined: May 20, 2007

Location: United States

Posted: January 03, 2008 at 8:53 PM / IP Logged

One more question about the Rockford Fosgate T10001BD amp is if it is mono then why is there a speaker A + and - and speaker B + and -? Can I use these both as and bridge like a normal amp? Or just use one set and run the speaker the same as normal? I am currently running one 2ohm DVD sub I have wired to a 1 ohm load. Any sugestions?

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

rf t10001bd

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.