amplifier, sub wiring

Home / the12volt's Install Bay / Car Audio / amplifier, sub wiring (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

sedate

Silver - Posts: 1,173

Joined: July 03, 2004

Location: Colorado, United States

Posted: January 12, 2008 at 8:41 PM / IP Logged

dk888 wrote:

4 Ohm and when I connect it to the amp, do I bridge it or keep the channels seperate

Bridge the RF amplifier and make the woofers look like the "4-ohm" schematic on the link I posted - the bottom image on the page. Do NOT wire the woofers to the "1-ohm" schematic - hooked to either the RF or the MTX, this would (well . . . could) cause serious damage!

Series the voice coils, parallel the woofers, bridge the amp! Ok?!

"I'm finished!" - Daniel Plainview

Dk888

Member - Posts: 6

Joined: April 07, 2005

Location: United States

Posted: January 14, 2008 at 12:03 AM / IP Logged

Thanks Sedate.. I'll give it shot during the week. Wire to 4 Ohm and bridge it on the amp. I hope my quarter panels fall off with the bass!

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

amplifier, sub wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.