the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2008 Nissan Titan, Alarm/Remote Start Wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
TJ92Civic 
Copper - Posts: 161
Copper spacespace
Joined: November 13, 2004
Location: United States
Posted: January 23, 2008 at 11:19 AM / IP Logged  
Anyone have the wiring diagram for a 2008 Nissan Titan? Thanks. Or is it the same as an 07?
KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: January 23, 2008 at 8:06 PM / IP Logged  
12 VOLTS Green Ignition Harness   + 
 IGNITION BLACK/ Red Ignition Harness   + 
 ACCESSORY Red Ignition Harness   + 
 STARTER Brown Ignition Harness   + 
 STARTER 2 Lt.Green Ignition Harness   + 
 KEY SENSE RED / blue Ignition switch harness   + 
 TACH SIGNAL SEE NOTES    AC 
 This vehicle has independent coils, there are three wires per coil, WHITE/ Blue, Black and the third is the tach signal wire.
 FUEL INJECTOR Opposite of White At any injector on engine   AC 
 LOCK Blue At switch inside driver's door   - 
 You must run wires into the doors to connect to these wires. The first pulse on the RED will disarm and a double pulse will unlock the doors.
 UNLOCK Red At switch inside driver's door   - 
 You must run wires into the doors to connect to these wires. The first pulse on the RED will disarm and a double pulse will unlock the doors.
 DOORPIN SEE NOTES      
 Driver's door is LT.BLUE, front passenger door is RED / BLUE. The left rear door is RED / YELLOW and the right rear door is RED / WHITE. All 4 wires are (-) and found at the BCM on the right side of the steering column.
 R.A.P. SHUT DOWN Lt.Blue SEE NOTES   - 
 This vehicle is equipped with automatic headlights that will stay on after a remote shutdown.you must pulse the drivers doorpin wire to shut the lights off. Drivers doorpin is Lt.Blue at BCM on right side of steering column.
 FACTORY ARM Arms with lock wire      
 FACTORY DISARM Disarms with unlock wire      
 BRAKESWITCH RED / Green At brake switch   + 
 PARKLIGHTS RED / Blue At dimmer switch   + 
 HAND BRAKE Green At switch on handbrake lever   - 
 HORN RED / White At steering column harness   - 
 VSS WIRE WHITE/ red Behind instrument panel   AC 
TJ92Civic 
Copper - Posts: 161
Copper spacespace
Joined: November 13, 2004
Location: United States
Posted: January 24, 2008 at 12:01 PM / IP Logged  
Thank you! I wonder how much of a pain it's going to be to get to the lock wires in the door...
TJ92Civic 
Copper - Posts: 161
Copper spacespace
Joined: November 13, 2004
Location: United States
Posted: January 24, 2008 at 12:32 PM / IP Logged  
R.A.P. SHUT DOWN Lt.Blue SEE NOTES   - 
 This vehicle is equipped with automatic headlights that will stay on after a remote shutdown.you must pulse the drivers doorpin wire to shut the lights off. Drivers doorpin is Lt.Blue at BCM on right side of steering column.
This means that I will need to connect the pulse after shutdown (Prestige APS -620) to the driver's doorpin correct? Sorry I am a little bit rusty.
TJ92Civic 
Copper - Posts: 161
Copper spacespace
Joined: November 13, 2004
Location: United States
Posted: January 24, 2008 at 12:36 PM / IP Logged  
STARTER 2 Lt.Green Ignition Harness   + 

And this will require the (-) Pulse during crank (Black / Yellow) to be used with a relay correct?

Again sorry for all the questions.

KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: January 24, 2008 at 1:12 PM / IP Logged  
TJ92Civic wrote:
R.A.P. SHUT DOWN Lt.Blue SEE NOTES   - 
 This vehicle is equipped with automatic headlights that will stay on after a remote shutdown.you must pulse the drivers doorpin wire to shut the lights off. Drivers doorpin is Lt.Blue at BCM on right side of steering column.

This means that I will need to connect the pulse after shutdown (Prestige APS -620) to the driver's doorpin correct? Sorry I am a little bit rusty.

Yes.... this will (of course) simulate opening the door.

If your unit has a negative starter output, yes, use this with a relay to do second starter. If iot does not, you can use the main starter output to trigger the relay for second.


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer