the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2003 kia spectra audio wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
spdbga 
Member - Posts: 2
Member spacespace
Joined: February 09, 2008
Location: Delaware, United States
Posted: February 09, 2008 at 8:09 AM / IP Logged  

Hey Guys, I'm truying to Install a ne stereo in my Car and I was wondering if you can help me with the wiring diagram. I couldn't find it anywhere. So please If you can help me it will be greatly appreciated.

Thanks,

Deyan

jeffwhiteman 
Copper - Posts: 124
Copper spacespace
Joined: October 20, 2006
Location: United States
Posted: February 09, 2008 at 10:56 AM / IP Logged  

+12V DC Battery(Constant)

Pink 

Switched Accessory

Green 

Ground 

Black 

 

 

Illumination 

Blue/white & blue/black 

Left Front + 

WHITE/ black 

Left Front - 

WHITE/ green 

Right Front + 

Yellow/red 

Right Front - 

Yellow/white 

Left Rear + 

BROWN / green 

Left Rear - 

BROWN / black 

Right Rear + 

ORANGE / black 

Right Rear - 

Lt.GREEN/ YELLOW 

Dont forget to test first!

jeffwhiteman 
Copper - Posts: 124
Copper spacespace
Joined: October 20, 2006
Location: United States
Posted: February 09, 2008 at 10:59 AM / IP Logged  

Oops, sorry about that

Try this

+12V DC Battery(Constant) Pink    Room  10 Amp  Fuse box at left rear side of engine compartment 

Switched Accessory Green    Audio  10 Amp  Fuse box behind left kick panel 
Ground  Black   
Illumination  Blue/white & blue/black   
Left Front +  WHITE/ black   
Left Front -  WHITE/ green   
Right Front +  Yellow/red   
Right Front -  Yellow/white   
Left Rear +  BROWN / green   
Left Rear -  BROWN / black   
Right Rear +  ORANGE / black   
Right Rear -  Lt.GREEN/ YELLOW   

spdbga 
Member - Posts: 2
Member spacespace
Joined: February 09, 2008
Location: Delaware, United States
Posted: February 14, 2008 at 12:53 PM / IP Logged  
Hey Again :), I have a problem I just Installed Kenwood KDC-MP238 CD-Receiver in my Kia Spectra 2003, and I was wondering where am I suppose to connect the Illumination wire to the Kenwood, because My dash board and my Stereo do not lit up when i turn the key. Thanks In Advance.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer