radio shack project board

I recently bough tone of those small project bords from Raido shack. the issue is

it has three sections on large in the center and two small ones one on each side of the large one. the small ones can be taken off etc..

Anyway. i tried to get it to work with some extra L.E.D.s i had laying aroudn i had to peel and stick the thin aluminum pannel on the back of it. This allows the power to go threw the borad.

EXCEPT. i dont have power in the center section of the bord. I really need more then two lines of powerd holes so tha ti can make the project i wanted to do.

So the question i have is am i suposed to jump a power wire from one section to the other? or  am i missing somethign to make it work?

I need to run 12 volt power threw it but it has to use a res. to lower it enough to use the LED.s ( i dont remeber what specs on them but they were just extras so i will not be useing them anyway they are just for testing things. )

Im trying to figure out the circuts i need for tail lights with a intergrated strobe light in them and also a turn signal in them.  but that is for a diffrent topic .

Thanks for all your help in advance.

never mind figured it out just took some time.

and looking at it enough to relise the stupid mistake i was doing lol

i was tired