Sub Noise

Home / the12volt's Install Bay / Car Audio / Sub Noise (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

bberman1

Gold - Posts: 2,314

Joined: March 11, 2002

Location: United States

Posted: March 16, 2003 at 5:53 PM / IP Logged

if you play with the connector right where the wires go into it dose the noise go away? Also what wire is that the blue one is going around ( the black wire) ?

Back to Top

spyder1125

Member - Posts: 22

Joined: March 15, 2003

Location: United States

Posted: March 16, 2003 at 6:15 PM / IP Logged

if by the blue one you mean the remote going toward the right side it is the pos. wire. also realize this is an old setup, and they're no long tangled like in that picture, each one is wrapped in black splite wire loom. it appeared that the noise went away when i was messing with in, what would be toward the left of the picture, where the blue RCAs connect with the purple RCAs

Back to Top

bberman1

Gold - Posts: 2,314

Joined: March 11, 2002

Location: United States

Posted: March 16, 2003 at 6:25 PM / IP Logged

That black wire loom won’t do anything as far as preventing interference. But you say the noise goes away when you play with the rca cables. Are you using RCA Interconnects to connect the two cables? If so undo the connection and put it back together see if that helps. If the noise goes away when you play with the rca cables than you know that that’s the problem. If you can try and replace them one of them could have gone bad you would be surprised it dose happen.

Back to Top

spyder1125

Member - Posts: 22

Joined: March 15, 2003

Location: United States

Posted: March 16, 2003 at 6:50 PM / IP Logged

i just remembered that the rcas came with a 3rd wire in the middle and said it could be used as a remote or ground islolator, i'm not using it as a remote but i know that i connected it to the seat bolt on the driver's side, but the other end of this wire is not connected to anything, wouuld that cause noise too? i still have the car in my garage, and just took some pics to help you out. i know the loom doesn't do anything, but i just cleaned up the mess to make it look nice to the cables aren't all crossed over each other.

http://www.hpphoto.com/servlet/com.hp.HPGuestLogin?username=spyder1125&password=43656685

i just took these pics, hope they help to give you an idea of what is going on Sub Noise - Page 2 -- posted image.

Back to Top

bberman1

Gold - Posts: 2,314

Joined: March 11, 2002

Location: United States

Posted: March 16, 2003 at 6:58 PM / IP Logged

Have not reviewed the pics but try and disconnect that wire and see what happens there is a possibility that it is causing interference.

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Sub Noise

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.