Hey all!
Sorry for what turned out to be such a long post but I wanted to get everything I could think of out of the way. Well, I've looked and listened on the RoE, The 12 volt, and Steve Meade forums for a while and now I'm proud to say that I'm about to have all the components I need for my install. So here I am, head bowed and humbled, to ask for everyones opinion, guidance, assistance. I just want to say that I really appreciate ANY help thats tossed out as I am a total n00b to installs and have NEVER done it before. But to continue, I have a 2000 Ford Explorer XLS. Installed so far; (by firedog :P)
H/U - Alpine CDE 9870
Front Door Speakers – Kicker DS680.2 (6x8 + 3/4” Tweets)
Amp Install – Power Acoustik PS1-4000D (Monoblock Class D)
at my house waiting I have;
4x Kicker CVR15-4
In a week or two most Ill be ordering;
2x Dual 15 Slot Vented Enclosures
A Set of Kicker DS680's for the rear doors
Plus the wiring necessary to do the job
(Ill also be having the windows tinted)
I originally intended on doing this install as an “all out balls to the walls” design with all four subs in a custom fitted enclosure forward facing, vented, and taking up the entire cargo section of the truck, but my paycheck limits me from doing that lol. So instead, tired and disgusted of my subs and amp sitting in the closet not getting used, Im settling for two dual chamber, slot vented, premades with 2.25 cubes per chamber. But this is where I need the help though, The subs will be wired in series for a total load of 2ohms. The amp is one ohm stable so Im good there. But when I go to install the subs in these premade enclosures what size wiring do I run from the amp to the speakers? And from speaker to speaker? And how do I go from speaker to speaker with 2 boxes? Any suggestions or known workarounds? This has to work and I want it to flex... well.... At least as best as it currently can.
Amp and Sub Specs
Total Package
@ Min - 1000
@ RMS - 2000
@ Peak - 4000
Per Sub
@ Min - 250
@ RMS - 500
@ Peak – 1000
Amp
@4Ohm - 1200rms
@2Ohm - 1700rms
@1 Ohm - 2200rms
@ Peak – 4000
And Finally; could someone walk me though the door speaker install? All that I really need to do is take off the door panel, take out the factory speaker, then swap that out with the new set of kickers right? I won't have to use new wiring in there will I? And how do I remove the door panel without causing damage? I'm really hoping to avoid having to buy anymore special tools or anything like that as of right now. And lastly how do I remove the panel without causing damage to my suv?
Once again, sorry about the long post but I just wanted to get it all out that I could think of. I really appreciate everyones help in advance. Thanks a lot,
Josh C.