remote start in 06 grand caravan

I had a CodeAlarm  CA440SS installed in my van and when you put key in after it's running all accessories turn off until you put you're foot on the brake and wait about 3-5 seconds.  Is there any way to get around this so accesories stay on or is this something i have to live with.

you need to interupt the mux wire

sorry but i'm just looking for info i can tell my installer, would you be able to provide some more details on this?

I should also add the pkuch2x bypass was installed with the rs

Whatever he connected to the PURPLE / brown wire at the ignition switch wasn't necessary. The tech sheets list a resistor to be connected to the PURPLE / brown, but the van will remote start and run just fine without it. If I were him, I would just disconnect whatever he put on there. Or, as robertsc said, he could/should use the relay he's already using, but use it to also interrupt the car's PURPLE / brown wire during remote start, as follows: 85: ground-when-running from remote starter 86: fused constant power 87: appropriate resistor, with other end of resistor connected to ground ------CUT CAR'S PURPLE / BROWN WIRE IN HALF----- 87a: key side of PURPLE / brown 30: body side of PURPLE / brown

Thank-you very much guys, i will pass this info on and see what happens!!