where to mount anti grind relay

Hello, about to attempt an install in a 2006 Mazda Tribute. I have done alarm/remote starts before in a former life. Where do you suggest to mount the anti-grind relay? Should I run some leads from under the dash to the starter wires in the ign column? Or try to stuff the relay IN the ignition column? Should I use 10GA, 12GA etc for the starter? Thanks -Roger

what model and brand are you installing?

just cut the wire from the ignition harness make sure the starter side and the the starter wire from the R/S connected on 30 on the relay and that the key side of the wire is on 87a and connected up your 86 to 12v and then a ground while running wire off the R/S to 85. As for where to put relay, where it will be the most out of the way for you location should not really matter as long as the connections are right.

as for the wire size the same as or bigger then starter wire will be fine

Thanks guys.. Appreciate the help.