the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

ppi and alphasonik amp


Post ReplyPost New Topic
< Prev Topic Next Topic >
toomtoomvroom 
Member - Posts: 8
Member spacespace
Joined: May 17, 2009
Location: California, United States
Posted: May 17, 2009 at 7:48 PM / IP Logged  
Hey there, first off thanks for reading and for any input you can give. I have an PPI PC6600 and a Alphasonik PMA5753A The specs are
Alphasonik PMA5753A
75 X 4 + 260 x 1 @4ohms
125 x 4 + 400 x 1 @2ohms
PPI PC6600
6 x 50W @ 4 ohms
6 x 100W @ 2 ohms
3 x 200W @ 4 ohms bridged
Will either of these amps be able to run a 8W7 without any problems? And why do these amps only have front and rear inputs? Why not inputs for subs? I know Alphasonik arn't really known for their amps or quite frankly anything else, prob why they went bankrupt, but after hearing one at a store i figured i'd try it out. I also got it for dirt cheap so that helps too. Once again thanks for any help.
One last question, does anyone know where i can get a bass remote for the Alphasonik? It's a 4 pin telephone jack type. I have the remote, but on the remote it's a 6 pin. I don't know if they have a cable from 4pin to 6pin, or if the remote i have is for a different Alphasonik Amp.
i am an idiot 
Platinum - Posts: 13,672
Platinum spaceThis member consistently provides reliable informationspace
Joined: September 21, 2006
Location: Louisiana, United States
Posted: May 17, 2009 at 8:27 PM / IP Logged  
What impedance is the 8W7?   I know that they will handle tons of power.  If it is available in a dual 4 ohm or a single 2 ohm coil, the 400 watts from the Alphasonik may be enough power for that driver. 
ianarian 
Copper - Posts: 516
Copper spacespace
Joined: April 24, 2009
Location: California, United States
Posted: May 17, 2009 at 9:05 PM / IP Logged  
You can get the w7 to play without problems, Yes. Its possible.
"Opiniarian"(Ianarian+Opinion): W7'S are a different level of just speakers and amps. I wouldnt do it.
As far as the inputs, are the amps older models? That may be why they were cheap.
I cant recall Alpha having remote LPL's on that 5ch. I remember the voltage meter port that they had. In the phone world though, 4 pin(rj11) plugs into a 6 or 8 pin but only uses the pins that connect on both sides. But if that remote is suppose to be for that amp, they may have a weird pin-out that they configured. I would try to find that certain patch cord to see if it exists. Google will tell ya.
toomtoomvroom 
Member - Posts: 8
Member spacespace
Joined: May 17, 2009
Location: California, United States
Posted: May 17, 2009 at 9:59 PM / IP Logged  
I think the W7 only comes in 3ohms.
Hey ianarian, why wouldn't you recommend it? Also thanks but i've tried to google it a million times. It's hard since the company has gone out of business to find much information. I've actually found their UK website with all their products, but it wasn't very helpful.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Sunday, May 12, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer