rca's popping when plugging in?

I really think the warranty has expired on the D1, but that is just me..  Easier than doing the repair as pictured, on the RCA harness on the D1, The RCA cables are stripped and black heat shrink tubing is placed over the shield wires of the cables.  It is very easy to cut through the heat shrink tubing to expose a bit ot the Shield.  Now using some very small wire, one conductor of an IDE hard drive cable works really good.  simply strip a very small amount of the insulation off of the ribbon cable and solder it to the shield you exposed earlier.  Now ground the other end.  Of course you need to put the fuse in there.  Read My last post carefully.  Like I said make sure you put the fuse. 

Actually repairing the deck with the new surface mount fuse is not an easy task.  60 dollars is cheap to get it repaired.