00 rodeo factory keyless alarm

so i have been putting off messin with the remote start i started in the winter so this last weekend it was time i hooked up the second ignition wire and i now have a blower when i remote start so i thought i would mess with the locks so i have a factory alarm keyless entry (of wich i know it works i set it off alot ) and i have a small problem the wiring says the lock is at the keyless (to the right of the glove box) i hooked it up and wala it locked my truck then it says unlock is at the drivers kick pannel a red and blue wire in the white 22 pin i found one in the black pin and its not the unlock but there is a red and blue at the keyless box and again it unlocks with my galaxy  so heres my problem if i arm my new system and dont arm the factory system they both go off after about 15 minutes but if i arm both the are fine all i have to do is carry 2 remotes and disarm them both or arm them both  so im totally lost any help is greatly appriciated

thanx all

nevermind, at the top, duh.

its all good

i have the scytec galaxy 5000 remote start alarm system

im almost sure i have that hooked up

like i said i started it over the winter the only thing i never hooked up was the second ignition and the locks

oh and one other thing

when i arm the galaxy it "chirps" like 5 times ??

I too vote for CKeeler's idea. 

	WIRE		COLOR		POLARITY		LOCATION
	Battery		WHITE/ BLACK		(+)		OR WHT SWITCH HARNESS
	Ignition 1		BLACK / YELLOW		(+)		IGNITION SWITCH HARNESS
	Starter 1		BLACK/ WHITE		(+)		IGNITION SWITCH HARNESS
	All Door Trigger		RED / GREEN		(-)		DRIVERS KICK WHT PLUG
	Trunk Trigger		GREEN/ GRAY		(-)		WHT PLUG IN DR. SIDE PANEL
	Alarm Disarm		YELLOW/BLUE		(-)		DRIVERS KICK WHT PLUG
	Alarm Arm		PPL		(-)		DRIVERS KICK PANEL
	Parking Lights		GREEN/ RED		(+)		DR. SIDE KICK PANEL OR SWITCH

ill check on that asap thanx guyz   

any other input is greatly appriciated