Well finally had some free time and installed viper into my car. Everything works great (alarm, keyless entry). Almost everything..
First thing. Can't get into basic features menu using valet/program button. All that instructions in manual's page 22 doesn't work. Therefore i can't program 2way remote pager. That one way pager (without a screen) works. The only thing what i can get with that valet/program button is long term event history (page 39).
Viper's install manual link. Any suggestions? Could it be a reason of bad wiring?
My wiring:
Primary Harness (H1) 12 Pin
H1/1 RED / White (-) 200mA Channel 2 output (trunk release) >> disconnected
H1/2 Red (+) Constant 12V Power Input (15A fused) >> 12volts / red / + / ignition harness
H1/3 Brown (+) siren output >> siren red wire
H1/4 Yellow (+) switched Ignition Input, Zone 5 >> Ignition / BLACK/ orange / (+) / ignition harness
H1/5 Black (-) Chassis ground Input >> to the ground (paint free sheet metal location)
H1/6 Violet (+) Door trigger input, Zone 3 >> disconnected
H1/7 Blue (-) Instant trigger Input (trunk input/shunt), Zone 1 >> disconnected
H1/8 Green (-) door trigger input, Zone 3 >> door trigger / RED / white / (-) / driver kick panel
H1/9 BLACK/ white Domelight Supervision Relay Output #30 >> dome supervision / used door trigger
H1/10 WHITE/ blue (-) 200mA Channel 3 programmable Output >> disconnected
H1/11 White (+)/(-) selectable light flash output >> parking lights / lt. Green / (-) / steering column (set jumper to negative)
H1/12 Orange (-) 500mA Ground-When-Armed Output >> disconnected
Auxiliary Harness (H2) 8 Pin
Nothing wired here.
Door Lock Harness 7 Pin
H3/A BLACK/ White Domelight Supervision relay Input #87 >> to the chassis ground (door pin circuit negative)
H3/B - H3/G Type B - Three wire (-) ground pulse controlling factory lock relays
H3/B WHITE/ Black Lock #87 Normally Closed >> disconnected
H3/C GREEN/ Black Lock #30 Common (output) >> power lock / brown / (-) / passenger kick or BCM
H3/D Violet/Black Lock #87 Normally Open (Input) >> to chassis ground w/ violet wire
H3/E BROWN / black Unlock #87 Normally Closed >> disconnected
H3/F Blue/Black Unlock #30 Common (output) >> power unlock / yellow/black / (-) passenger kick or BCM
H3/G Violet Unlock #87 Normally Open (input) >> to chassis ground w/ violet/black wire
And the second question would be regarding immobilizer. I didn't wired it because i found another alarm installed in my car with immobilizer. Can i wire viper's immobilizer? Can two installed immobilizers damage anything?
Immobilizer Wire Connection 3 Pin
A GREEN/ Black Starter - Normally Closed (motor side) >> starter / BLACK/ white / (+) / ignition harness (to the starter circuit)
B Green Starter Normally Open (motor side) >> not used
C GREEN / WHITE Starter Common (key side) >> starter / BLACK/ white / (+) / ignition harness (to ignition switch)