ultra start in grand cherokee

Hi all.  My first post here. 

I'm going to install an Ultra Start remote starter in my '99 Grand Cherokee.  The vehicle does not have a Sentry Key system, so I don't need a bypass.  Wondering if anyone can help me out. 

Exactly what wires in the column to tap into, resistor(s) and/or relays required, etc. I only want the unit to function as a remote starter (no door locks, trunk, etc.).  I'm a bit confused with the parking light part too - does it really need a relay and resistor, or just a resistor?  On this site, I've got the wiring description for my vehicle (I'm good with that), as well as the Installation Note for Jeeps which eliminates the reqmt. for a resistored parking light circuit - connects directly to the parking light relay terminal. 

Anybody have any idea why my starter (Ultra Start) would have 2 12 volt inputs?  Do I just use one of them?  Also, according to Bulldog Security's wiring guide on their site, it says parking light system should use the negative output from my module.  Can anyone confirm this?  The wires for my starter are:Starter Output (+) YELLOWHeater/Accessory Output (+) GREEN12 Volt Input (+) 30amp RED12 Volt Input (+) 30amp REDSelectable Output (+) WHITEIgnition Output (+) BLUEDiesel wait to start input (+ or -) BLUEBrake Switch Input (+) PINKHorn Output (-) WHITE/ BLUESystem Ground Input (-) BLACKPark Light Output (+) 10 amp WHITEHood pin switch Input (-) GREEN / WHITETach Detection Input (A/C) BLUE/WHITERe-arm Output (-) YELLOWTrunk Release Output (-) RED / WHITEDis-arm Output (-) 250ma BROWNNegative Park Light Output (-)250ma ORANGEGround While Running Output WHITE/ VIOLETAppreciate any help you can offer!Jason

Disregard, I posted in wrong section, sorry. 

It has 2 12 volt inputs...One is for system power...The other is for starter output...This is common...M.E.C.P & First-Class

Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!