2004 saturn ion remote start success

After a lot of stress I have successfully installed a Prostart CT-3460 TW and DEI PLJX in a standard ION. I think this is a Canadian Tire only starter. No power door locks. I figured I would post here and save someone the frustration i had. These are all the wires I used. CT-3460 6pin Yellow - IGN - PLJX Pink Ign and Car Blue wire at IGN Red x2 - Battery - Car Large Red Wire on power steering under steering wheel Orange - ACC - Car Brown wire at car ignition key Purple - Starter - PLJX Voilet Start Green - Clutch - Car Yellow wire on clutch, 5th relay jumper to run CT-3460 5pin Black - Gnd - Car Gnd to the chassis with a tech screw Purple - Tach - Car White tach wire on engine Grey   - Hood - Hood pin switch, find a good spot by the front Orange - Brake - Car Lt-Blue wire on the foot brake switch Yellow - PLites - Car Brown wire on light switch CT-3460 12pin Grey   - Door - Car Lt Green drivers kick panel White - GWR - PLJX Brown Ground when running after programming Orange - Pbrk - Car Lt Blue Park brake switch PLJX Brown - GWR - CT-3460 12pin White after programming Blue   - Data - Car White wire at Ign cut to BCM Voilet - Start - CT-3460 6pin Purple PnkWht - Data - Car White wire at Ign cut to Key Pink   - IGN - CT-3460 6Pin Yellow and Blue at car IGN Red    - Bat - Car Constant 12 volt Black - Gnd - Car Chassis ground Only one wire is cut at the Ign key all the rest are soldered and then wrapped with tape and then tywrapped. Make sure the PLJX is jumper to ION. I had some trouble with the PLJX, make sure you don't connect the brown wire until you have the unit programmed. Program the remote start to the remote and then program the tach sense and you should be ready to go. I got the car diagram here and the others came with diagrams. It is running now, but if anyone on here see's something i did wrong please tell me. If you have any questions reply. Have a good one hope it works for you.

Moonliter hmm interesting that you say that, says right on the box that its a manual start system. Plus the fact that it has a ready mode, clutch bypass and park brake system. I might be wrong but your welcome to look at the install instructions on prostarts site. http://www.autostart.ca/prostart/manuals_en.php http://www.engines911.com/asdocs/CT-3460TW_ig_en_h370s380v250_040908.pdf

No problem had me worried for a minute there.