2006 2007 hhr wiring guides

Just looking for the wiring codes for these 2 years of vehicles. I am doing a couple GPS tracking units with door unlock. Thank you.

chevorlet of coarse, sorry.

2006 - 2007 HHR Battery RED / BLACK (50 AMP) (+) AT BCM C3 CONNECTOR PIN D1    Ignition 1 YELLOW (+) IGNITION HARNESS Door Lock Circuit ONE WIRE RISISTOR BASED    Power Unlock WHITE (-) DRVERS KICK PANEL GROUND THROUGH A 1500 OHM RESISTOR    PowerLock WHITE (-) DRVERS KICK PANEL STRAIGHT GROUND If i Can't Install it    I Don't need it   Joe

Starter 1 YELLOW (-) ECM BLUE CONNECTOR PIN 56 OR PIN 46 THIS VEHICLE STARTS WHEN IGNTION POWER IS APPLIED AND ACCESSORY POWER IS LOST, no problemIf i Can't Install it    I Don't need it   Joe

mazda 6t9 - Can you specify what you need the starter wire for (e.g. remote start, or starter interrupt) - the HHR, along with most other late model GM products, doesn't have a conventional starter wire at the ignition switch, so the interface is a bit different. C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two

I need it for a starter kill for GPS disable.

starter wire is yellow -       @ ECM, BLUE Plug, Pin 56 or 46

What color is the ignition wire as well the module requires an ignition source thanks

As listed above, the yellow wire in the ignition harness would be an ignition source. Also I've found there's a thin(maybe 18 ga.) pink wire in the red plug at the BCM which shows ignition voltage whether turned on with the key or the factory remote start. Additionally, if you don't care about disabling the factory remote start with your starter kill, wire a relay to connect the yellow and brown wires at the ignition switch when the starter kill is active.C Renner's Auto Electronix

My service is cheap, quick, and good - pick any two