remote starter/alarm 06 magnum

I am trying to install a remote start/alarm on my magnum and I am using the DB-CHDL7P2  bypass module and I have a couple of questions.

1. Are you able to program the module if you are using 2 different keys (intergrated remote/transponder)? They both work with the vehicle.

2. If the answer to the above is yes, when programming the module is the module suppose to light up or just the security light on the vehicle?

3. The directions for the bypass want me to connect its starter wire parallel to the vehicle starter wire and the remote starter wire, am I suppose to cut the vehicles wire and connect one end to the bypass and the other to the remote start?

Can someone please help me if you have any experience with this module and vehicle. I worked on this all day with no luck, I bought this particular bypass because I thought it would save me alot of time.

Yes, you will need both of these keys.

Look at the instructions for programming. Usually you have to look at BOTH the LED on the Magnum as well as the programming LED on the module

No, just tap into the starter wire, if you cut it you will not have control over the starter witht he key.

Ok, I got everything hooked up. My lights flash, blower comes on, and doors lock, but i can not get it to remote start. When i try to remote start the the dash comes on and the blower kicks on but when it trys to start it doesn't do anything. The engine dosen't turn at all. I have tried the the 180 ohm resistor w/ relay and still nothing.  Does anyone have any ideas as to what wires I may have crossed or hooked up incorrectly? I am using a DB-CHDL7P2 bypass kit. Any help is greatly appreciated!