one pre out

Home / the12volt's Install Bay / Car Audio / one pre out (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

pubwoofer

Member - Posts: 13

Joined: November 09, 2009

Posted: November 20, 2009 at 1:49 AM / IP Logged

I am wanting to connect my one pre out hu to my 4 channel amp, i have two pairs of splitters but my amp has instructions to put one pair into left and right input and also one pair into left and right output(response precision AA0426 4 x 100 watt). is this right?? do i even use the splitters and just connect my one preout to the left and right input on the amp??. thx

Back to Top

DYohn

Moderator - Posts: 10,741

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

Joined: April 22, 2003

Location: Arizona, United States

Posted: November 20, 2009 at 10:34 AM / IP Logged

How do you intend to use the 4-channel amp?

Support the12volt.com

Back to Top

pubwoofer

Member - Posts: 13

Joined: November 09, 2009

Posted: November 20, 2009 at 1:02 PM / IP Logged

hi i,m using splits on the front (channel 1 and 2) and 1 sub will be bridged ( channel 3 and 4.)

Back to Top

DYohn

Moderator - Posts: 10,741

Joined: April 22, 2003

Location: Arizona, United States

Posted: November 20, 2009 at 2:31 PM / IP Logged

I've never heard of your amplifier, does it have separate HP filter for channels 1 and 2 and a LP filter for channel 3 and 4? If so, then sure you use a set of Y-cables and split the left out from the HU to both amplifier L inputs and the R to both R's. Set the LP and the HP to about the same frequency and set your input gain carefully. Good luck.

Support the12volt.com

Back to Top

pubwoofer

Member - Posts: 13

Joined: November 09, 2009

Posted: November 20, 2009 at 3:41 PM / IP Logged

hi yes it has filters for each channel, i think i found the problem, the instruction manual is unclear and shows connections going from the hu to the output plugs on the amp wich are for an external amp, will use splitters to each line in connection on the amp and ignore the instructions.The instructions are posted at the bottom of this page http://www.mr2.org.nz/phpBB2/viewtopic.php?t=6657&start=30 what do you think?.thx for your help

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

one pre out

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.